I got the first prototype a couple of weeks ago, and it is not perfect. A buddy of mine who teaches Industrial Design printed it for me and I didn't realize that it wasn't going to be plastic. It's a plaster/gypsum compound that is held together with resin, and it is heavy. It weighs a pound more than it would have if it were made of plastic. There seems to be a bit of a balance problem too. It might be fixable, but the bigger problem is that since it was printed in the wrong material, I can't fully tell if the connection system works. I have some more work to do to fix it, and I'll keep you all posted on it. Today with Mike was the first time it had been thrown and caught in the hand. Plus, Mike did some regenerations too. The way I made the tip means that it unscrews when lefties regenerate, so I have to get a reverse thread tap so I can actually use it in fixed-tip mode.