iTopSpin

Please login or register.

Login with username, password and session length
Advanced search  

News:

Author Topic: Spinjitzu  (Read 7211 times)

Jeremy McCreary

  • ITSA
  • Demigod member
  • **********
  • Posts: 3108
    • MOCpages
Re: Ninjago Spinjitzu Slam
« Reply #15 on: November 15, 2020, 12:54:28 AM »

@ta0: This is the first I've seen the Spinjitzu Burst version. May have to try one to see how the top works and to check out the parts, some of which I don't recognize from the video.
« Last Edit: November 15, 2020, 12:58:04 AM by Jeremy McCreary »
Logged
Everything in the world is strange and marvelous to well-open eyes. -- Jose Ortega y Gasset

ta0

  • Administrator
  • Olympus member
  • *****
  • Posts: 12383
    • www.ta0.com
Re: Ninjago Spinjitzu Slam
« Reply #16 on: November 15, 2020, 09:58:49 PM »

@ta0: This is the first I've seen the Spinjitzu Burst version.
I ordered without checking the details, so at first I was a little disappointed that I didn't get the hard shell version which should spin longer. But it worked slightly better than expected.

I printed an adapter to use the screw tip on one of my 3D printed tops. But launcher couldn't spin it fast enough.

Logged

Jeremy McCreary

  • ITSA
  • Demigod member
  • **********
  • Posts: 3108
    • MOCpages
Re: Ninjago Spinjitzu Slam
« Reply #17 on: November 19, 2020, 04:11:06 PM »

I ordered without checking the details, so at first I was a little disappointed that I didn't get the hard shell version which should spin longer. But it worked slightly better than expected.

I printed an adapter to use the screw tip on one of my 3D printed tops. But launcher couldn't spin it fast enough.

The launcher is disappointing even with the hard shell. No surprise that your peg top had too much AMI for the starting torque and spin-up time avaliable.
Logged
Pages: « 1 2  All   Go Up