iTopSpin

Please login or register.

Login with username, password and session length
Advanced search  

News:

Author Topic: Tip Advice  (Read 1715 times)

Sam

  • Gold Member
  • ****
  • Posts: 123
Tip Advice
« on: January 09, 2013, 02:38:22 PM »

Hey Guys. I'm trying to get better at making my top tips. I've read on here in several places that some of you use a metal rod in your delrin plastic tips. Do you drill a hole in the plastic rod the size of the metal rod then glue it in place? Or do you use some other means to get it in there?

I have 3/8 and 1/2 delrin plastic rods. Most of the tops I've been making are about 3-4 inches wide.

Thanks for the help.
« Last Edit: January 09, 2013, 02:42:00 PM by Sam »
Logged

johnm

  • Ultrahero member
  • *******
  • Posts: 863
Re: Tip Advice
« Reply #1 on: January 09, 2013, 08:07:45 PM »

In Neff's Misfit #2 thread (link) he describes his approach of drilling and tapping (threading) a hole in the plastic and then epoxying a matching screw/bolt into the plastic.  Eric offers an alternative to the epoxy for bonding to Delrin in the form of a 'super' type glue in his thread about Big fun with big Delrin (link).  The screw can extend beyond the top-body side of the plastic and then be installed in a hole or matching thread in the top body and the assembly can be secured with a nut inside the top.

For strength, choose the largest screw size you can such that the plastic at the neck or groove of the tip still covers the threads of the screw after you've turned the plastic to your desired neck diameter for the particular top.  It might be a bit of a surprise to reveal the steel screw while turning and without backfilling the exposed threads with something, the string will grab in that spot and be a source of frustration.

Good Luck!
Logged

Sam

  • Gold Member
  • ****
  • Posts: 123
Re: Tip Advice
« Reply #2 on: January 10, 2013, 12:11:49 PM »

Thanks John for the links and advice. I'll try it out and see how it goes.  :)
Logged